Silicon Sculptor adapter modules are package-specific and dependent on the product family, but are independent of gate count.
Silicon Sculptor Adapter Modules
SmartFusion2 and IGLOO2
IGLOO, ProASIC3 and Fusion
SmartFusion
ProASIC3, ProASIC , and ProASIC
Axcelerator and RTAX-S
Antifuse Devices up to SX-A and RTSX-S
Note: All Activator products and modules are obsolete. Microsemi recommends upgrading to the Silicon Sculptor products. Most mature
FPGA devices can still be programmed on Activator, but new FPGA families will not be supported on Activator.
Life cycles of Microsemi Silicon Sculptor modules
Adapter Type Typical Insertion cycle life
Module Base > 50,000 insertions
Standard Pitch Socket Modules 10,000 to 20,000 insertions
BGA Sockets Modules 2,500 to 10,000 insertions
Users should carefully insert and remove the module from the programmer to avoid damage to the DIN connectors. Typical insertion cycles can be
prolonged if the module base and socket modules are properly cleaned and maintained. Handling and cleaning practices can affect the number of
insertions achieved.
SmartFusion2 and IGLOO2 Adapter Modules
SmartFusion2 and IGLOO2 devices (including ARM-enabled versions) can be programmed with Silicon Sculptor 3 and Silicon Sculptor II using
STAPL programming files. The SM2S series of adapter modules, listed below, have been designed for use with SmartFusion2 and IGLOO2
devices. There is no In-System Programming (ISP) module available for SmartFusion2 and IGLOO2 devices; the FlashPro4 or FlashPro5
programmer must be used for ISP.
Type Package Adapter Modules Details
FBGA
FG676 SM2S-676FG-MSSOC
FG484 SM2S-484FG-MSSOC
FG896 SM2S-896FG-MSSOC
VFPBA
VF400 SM2S-400VF-MSSOC
VF256 SM2S-256VF-MSSOC
FCBGA
FC325 SM2S-325FCSR-
MSSOC
FC1152 SM2S-1152FC-MSSOC
FC325 SM2S-325FCS-
MSSOC
VQFP VQ144 SM2S-144VQ-MSSOC
IGLOO, ProASIC3, and Fusion Adapter Modules
IGLOO, ProASIC3, and Fusion devices (including ARM-enabled versions) can be programmed with Silicon Sculptor 3 and Silicon Sculptor II using
STAPL programming files. The SM3F series of adapter modules, listed below, have been designed for use with IGLOO, ProASIC3, and Fusion
devices. Whilst SMPA series modules may be used for ProASIC3 programming and some IGLOO programming (depending if the module has a
driver to the Flash*Freeze pin), SM3F series modules must be used for Fusion programming. All SM3F modules may also be safely used for
IGLOO programming. There is no In-System Programming (ISP) module available for IGLOO, ProASIC3, or Fusion devices; the FlashPro4
programmer must be used for ISP.
Type Package Adapter Modules Details
CS
CS81 SM3F-81CS-ACTEL
CS121 SM3F-121CS-ACTEL
CS196 SM3F-196CS-ACTEL
CS201 SM3F-201CS-ACTEL
CS281 SM3F-281CS-ACTEL
PLUS