PRODUCT BRIEF
Never stop thinking.
Infineon’s standard 4-band VDSL (4bVDSL) is a
highly integrated chipset designed for VDSL
DSLAM/Line cards and CPE applications.
VDSL is a robust, fully standardized technology.
Infineon’s 4-band VDSL system solution delivers
transmission speeds exceeding 65 Mbit/s1). It also
provides symmetric 16 Mbit/s or asymmetric
26/3 Mbit/s broadband services at a distance of up
to 5000 ft (1500 m) over existing copper wires.
Higher rates are possible with reduced ranges.
Infineon’s ATM VDSL chipset implements QAM
modulation, as defined in the VDSL standards. Its
spectral allocation enables coexistence with voice
and ISDN services on the same line, as well as
with other xDSL technologies in the same bundle.
VDSL is an excellent way to speed up broadband
services for residential, business and commercial
environments. A typical VDSL application is the
“Last Mile Network” that offers high resolution
video, high-speed Internet and advanced tele-
phony services over a single twisted pair.
Features
■FTTC/Cab and broadband
extension over copper wire
■E1/T1 multiplexing or partial
E3/T3 over a twisted pair
■Quadrature Amplitude
Modulation (QAM)
■Frequency Division Duplexing
(FDD)
■4, 3 or 2-band operation
■High speed VDSL applications
according to ANSI, ETSI and
ITU-T standards
■Transmission of ATM cells over
VDSL using ATM-TC
■Dual latency support with built-in
interleaver memory
■IEEE 1149.1 JTAG test access
port
■Power Backoff
■Embedded AGC controller
■Embedded interleaver SRAM
■Backward compatibility with the
Infineon 2-band VDSL chipset
Performance
■Transmission rates exceeding
65 Mbit/s
■Standard data rates up to
16 Mbit/s for symmetric profiles
and 52 Mbit/s for asymmetric
■Up 40 Mbit/s symmetric data
rates are possible
■Versatile and completely flexible
band frequency allocation
■Robust operation under poor
conditions
■Full spectral compatibility with
amateur radio
■Blind timing recovery and
equalization algorithms
■RS-FEC coding with up to eight
bytes per code word correction
■Near end and far end digital
loopback capability
Interfaces
■ATM UTOPIA level 2 or level 1
dual latency PHYs, or level 1
dual latency master interfaces
■One, two or four E1/T1 interfaces
■External host parallel port
■MII in both MAC and PHY modes
for Ethernet over ATM VDSL,
with integral AAL-5 and
RFC 2684 encapsulation
■PCM interface on the
non-interleaved (fast) channel
■Serial UART interface to a
standard serial terminal
■EEPROM interface (I2C)
Internal Processor Support
■Modem initialization and
monitoring
■Standalone cold start up
■Firmware upgrades
■Remote modem configuration
and management
Power
■1.8 V core with 3.3 V I/O
■Power Save modes
■Power Down with fast warm start
■Low power consumption
(1.5 W for minimal operation)
■Sleep mode and Wake Up
■Remote Wake Up
4-band VDSL
Standard Very High Bit-rate DSL Chipset
PEF 22810 (VDSL-L)
PEF 22815 (4bVDSL-A)
PEF 22814 (4bVDSL-D)
1) Speeds above 40 Mbit/s will be available from PEF 22814 V2.0.