SW-313-TB - M/A-Com Technology Solutions

Matched GaAs SPDT Switch,

DC-3.0 GHz with TTL/CMOS Control Input

Rev. V6

SW-313-PIN

1

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

1

Features

 Integral TTL Driver

 Low DC Power Consumption

 Fast Switching Speed: 7 ns Typical

 Hermetic Surface Mount Package

 50 Ohm Nominal Impedance

 MIL-STD-883 Screening Available

 Lead-Free CR-9 Package

 260°C Reflow Compatible

 RoHS* Compliant

Description

M/A-COM’s SW-313-PIN is a GaAs FET SPDT ab-

sorptive switch with integral silicon ASIC driver.

Packaged in a 16-lead ceramic surface mount pack-

age, this device offers excellent performance and

repeatability from DC to 3 GHz while maintaining low

power consumption. The SW-313-PIN is ideally

suited for use where fast speed, low power con-

sumption and broadband applications are required.

MIL-STD-883 screening available.

Ordering Information

Part Number Package

SW-313-PIN Bulk Packaging

SW-313-TB Sample Test Board

Note: Reference Application Note M513 for reel size

information.

Functional Block Diagram

Pin Configuration

Pin No. Function Pin No. Function

1 Vee 9 RFC

2 GND 10 GND

3 GND 11 GND

4 GND 12 RF1

5 RF2 13 GND

6 GND 14 GND

7 GND 15 Vcc

8 GND 16 C1

* Restrictions on Hazardous Substances, European Union Directive 2002/95/EC.

The metal bottom of the case must be connected to RF and DC

ground.

RFC

GND

RF1

GND

RF2

GND

GND Orientation Mark

Vee

Vcc

C1

Matched GaAs SPDT Switch,

DC-3.0 GHz with TTL/CMOS Control Input

Rev. V6

SW-313-PIN

2

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

2

Electrical Specifications: (From –55°C to +85°C), Z0 = 50 1,2

Parameter Frequency Units Min Typ Max Test Conditions

Insertion Loss DC - 3000 MHz

DC - 2000 MHz

DC - 1000 MHz

DC - 500 MHz

dB

—

1.2

1.1

0.9

0.8

—

VSWR DC - 3000 MHz

DC - 2000 MHz

DC - 1000 MHz

DC - 500 MHz

Ratio

—

1.50:1

1.40:1

1.35:1

1.30:1

—

Isolation DC - 3000 MHz

DC - 2000 MHz

DC - 1000 MHz

DC - 500 MHz

dB

35

43

48

53

—

Trise, Tfall — ns — 7 — 10% to 90%

Ton, Toff — ns — 18 — 1.3V CTL to 90% / 10%

Transients — mV — 25 — In-Band

1 dB Compression 0.05 GHz

0.5 GHz to 3 GHz

dBm

—

+25

+30

—

Input Power

IP2 0.05 GHz

0.5 GHz to 3 GHz

dBm

—

+60

+65

—

Two-Tone Input Power up to +5

dBm

IP3 0.05 GHz

0.5 GHz to 3 GHz

dBm

—

+40

+46

—

Two-Tone Input Power up to +5

dBm

Vin Low 0V to 0.8V — µA — — 1

Vin High 2.0V to 5.0V — µA — — 1

Vcc +5.0V ± 10% — mA — — 1

Vee -5.0V to -8.0V — mA — — 1

1. All specifications apply when operated with bias voltages of +5V for Vcc and –5V for Vee.

2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.

Matched GaAs SPDT Switch,

DC-3.0 GHz with TTL/CMOS Control Input

Rev. V6

SW-313-PIN

3

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

3

Absolute Maximum Ratings 3,4

Parameter Absolute Maximum

Max Input Power

50 MHz

500 - 3000 MHz

+27 dBm

+34 dBm

VCC -0.5V ≤ VCC ≤ +7.0V

VEE -8.5V ≤ VEE ≤ +0.5V

VCC - VEE -0.5V ≤ VCC - VEE ≤ 14.5V

Vin5 -0.5V ≤ Vin ≤ VCC + 0.5V

Operating Temperature -55°C to +125°C

Storage Temperature -65°C to +150°C

3. Exceeding any one or combination of these limits may cause

permanent damage to this device.

4. M/A-COM does not recommend sustained operation near

these survivability limits.

5. Standard CMOS TTL interface, latch-up will occur if logic

signal is applied prior to power supply.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

Gallium Arsenide Integrated Circuits are sensitive

to electrostatic discharge (ESD) and can be

damaged by static electricity. Proper ESD control

techniques should be used when handling these

devices.

Truth Table (Switch)

Condition of Switch

Control Input

RF Common to Each RF Port

C1 RF1 RF2

0 On Off

1 Off On

Isolation vs. Frequency

0

10

20

30

40

50

60

70

80

0.0 0.5 1.0 1.5 2.0 2.5 3

F re quenc y ( GH z)

Isolation dB

0 = TTL Low; 1 = TTL High

Typical Performance Curves

Insertion Loss vs. Frequency

0.00

0.50

1.00

1.50

2.00

0.0 0.5 1.0 1.5 2.0 2.5 3

F re quenc y (GH z)

Loss (dB)

VSWR vs. Frequency

1.00

1.20

1.40

1.60

1.80

2.00

2.20

0.0 0.5 1.0 1.5 2 .0 2.5 3

F re que nc y ( G H z)

VSWR

V SW R ( On)

V SW R ( Of f )

Matched GaAs SPDT Switch,

DC-3.0 GHz with TTL/CMOS Control Input

Rev. V6

SW-313-PIN

4

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

4

Lead-Free, CR-9 Ceramic Package†

† Reference Application Note M538 for lead-free solder reflow

recommendations.

Matched GaAs SPDT Switch,

DC-3.0 GHz with TTL/CMOS Control Input

Rev. V6

SW-313-PIN

5

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

5

Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM")

products. These materials are provided by MACOM as a service to its customers and may be used for

informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or

in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM

assumes no responsibility for errors or omissions in these materials. MACOM may make changes to

specifications and product descriptions at any time, without notice. MACOM makes no commitment to update

the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future

changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise,

to any intellectual property rights is granted by this document.

THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR

IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR

WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR

INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR

OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY

OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN

THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS,

WHICH MAY RESULT FROM THE USE OF THESE MATERIALS.

MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM

customers using or selling MACOM products for use in such applications do so at their own risk and agree to

fully indemnify MACOM for any damages resulting from such improper use or sale.