Memory Module Specifications KVR13N9S6/2 2GB 1Rx16 256M x 64-Bit PC3-10600 CL9 240-Pin DIMM DESCRIPTION SPECIFICATIONS This document describes ValueRAM's 256M x 64-bit (2GB) CL(IDD) 9 cycles DDR3-1333 CL9 SDRAM (Synchronous DRAM) 1Rx16, memory Row Cycle Time (tRCmin) 49.125ns (min.) module, based on four 256M x 16-bit FBGA components. The Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact Row Active Time (tRASmin) 36ns (min.) fingers. The electrical and mechanical specifications are as Maximum Operating Power 1.050 W* follows: UL Rating 94 V - 0 Operating Temperature 0o C to 85o C FEATURES Storage Temperature -55o C to +100o C * JEDEC standard 1.5V (1.425V ~1.575V) Power Supply *Power will vary depending on the SDRAM used. * VDDQ = 1.5V (1.425V ~ 1.575V) * 667MHz fCK for 1333Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB : Height 1.180" (30.00mm), single sided component Continued >> Document No. VALUERAM1369-001.A00 11/12/13 Page 1 MODULE DIMENSIONS: 133.35 Units: millimeters 30.00 0.15 0.15 8.00 0.15 0.00 0.15 54.70 11.00 0.15 18.80 0.15 0.00 15.80 0.15 Document No. VALUERAM1369-001.A00 Page 2