| Micro Networks Corporation 7 Mile Saudwidin ; , An Integrated Device Technology, Inc. company Part Number: SF0430BA02508S DESCRIPTION e 430 MHz SAW bandpass filter with 4 MHz bandwidth. 3.8x3.8 mm SMP. e RoHS compliant. TYPICAL PERFORMANCE Pit Transmissian Lag Mag {@.@ dB/Y Ref 4.44 dB c 2: 0fFf 7 an h 7 ms 7 H A \ -S8 Ss AIALY L eg hs yw -82 tt g A t | Center 434.848 MHz Span 100.4884 MHz Horizontal: Frequency: 10 MuHz/div Vertical from top: Relative Magnitude: 10 dBidiv IDT SAW Products 324 Clark Street, Worcester, MA 01606, USA e Ph 1-508-852-5400 Fax 1-508-852-8456 www.idt.com DSSF0430BA02508S Rev - 25-Apr-2006 Page 1 of 3QIDT Micro Networks Corporation An Integrated Device Technology, Inc, company 430 MHz SAW Filter 4 MHz Bandwidth Part Number: SF0430BA02508S SPECIFICATION Center Frequency ( Fc) ' - 430 - MHz Insertion Loss (Fe +/- 2 MHz) - 4 45 {dB Lower 1.5 dB Frequency - 427.6 428 |MHz Upper 1.5 dB Frequency 432 432.4 - MHz Passband Amplitude Ripple * - 12 1.5 |dBp-p Rejection (Fc-100 to Fc-40.8 MHz) * 50 55 - dB Rejection (Fc+40.8 to Fc+100 MHz) 50 55 dB Ambient Temperature - 25 - C Source / Load Impedance - 50 - QO Notes: 1. Average of the lower and upper 3 dB band edge frequencies. 2. defined over Fe +/- 2 MHz. 3. Dependent on PC board layout. MAXIMUM RATINGS Storage Temperature Range -40 85 C Operating Temperature Range -10 50 C Input Power Level : 0 dBm DC Permissive Voltage - 10 VDC MATCHING CIRCUIT 5 Input Output 50 2 502 Single-ended Single-ended 1,3,4,6 GND GND Notes: 1. External matching components are not required. IDT SAW Products 324 Clark Street, Worcester, MA 01606, USA e Ph 1-508-852-5400 Fax 1-508-852-8456 www.idt.com DSSF0430BA02508S Rev - 25-Apr-2006 Page 2 of 3Q)IDT. Micro Networks Corporation An Integrated Device Technology, Inc. company PACKAGE OUTLINE 3.8402 4 Thee 3.8402 [Hf Al] ioM 1.80 Package Material: Body: AleO3 ceramic Lid: Kovar, Ni plated Terminations: Au plating 1 um min, over a 1.3-8.9 um Ni plating 430 MHz SAW Filter 4 MHz Bandwidth Part Number: SF0430BA02508S Units: mm Tolerances are +0.15 mm except for the overall length, width and pad dimensions, which are nominal values. Pad Configuration: Input: 2 Output: 5 Ground: 1,3,4,6 All specifications are believed to be accurate and reliable. However, MNC reserves the right to make changes without notice. 2006 All rights reserved. IDT SAW Products e 324 Clark Street, Worcester, MA 01606, USA e Ph 1-508-852-5400 Fax 1-508-852-8456 www.idt.com DSSF0430BA02508S Rev - 25-Apr-2006 Page 3 of 3