AC244051 - Microchip Technology

AC244051, AC244052, AC244061 1/2

PEP and Debug Header Help

Required Debug Headers : AC244051, AC244052, AC244061

AC244051, AC244052, AC244061

Header IdentificationHeader Identification

The AC number is used for ordering the Processor Extension Pak, which contains the debug header. However, this number is not on

the header, as the board may be used for multiple headers by inserting different -ICE/-ICD devices. To identify these headers, use the

following information.

AC Number -ICE/-ICD Device Boar d Assembly Number

AC244051 PIC16F1509-ICE 02-02208

AC244052 PIC16LF1509-ICE

AC244061 PIC16F527-ICD

Header Setup and OperationHeader Setup and Operation

For these headers, there are no jumpers/switches. MPLAB X IDE will use its selected device to choose the correct device to emulate.

These headers support 8-, 14- and 20-pin devices. For 8- and 14-pin devices, make sure device pin 1 is placed at the 20-pin connector

pin 1.

Header LimitationsHeader Limitations

See the “Limitations” section in your debug tool online Help file for details.

Header DimensionsHeader Dimensions

The figure below lists the dimensions for the debug headers. Dimensions are design values in inches.

If the length and/or width of the debug header is too large a footprint for the target board, consider using stand-offs, transition sockets

or other extenders in the header connection socket to raise the header above the target.

Figure: Dimensions - AC244051, AC244052, AC244061