
3
IDT74FCT16373AT/CT
FAST CMOS 16-BIT TRANSPARENT LATCH INDUSTRIAL TEMPERATURE RANGE
Symbol Parameter Test Conditions(1) Min. Typ.(2) Max. Unit
IOOutput Drive Current VCC = Max., VO = 2.5V(3) –50 — 180 mA
VOH Output HIGH Voltage VCC = Min. IOH = –3mA 2 .5 3.5 — V
VIN = VIH or VIL IOH = –15mA 2 . 4 3. 5 — V
IOH = –32mA(4) 23—V
VOL Output LOW Voltage VCC = Min. IOL = 64mA — 0.2 0.55 V
VIN = VIH or VIL
IOFF Input/Output Power Off Leakage(5) VCC = 0V, VIN = or VO ≤ 4.5V — — ±1 μA
Symbol Parameter Test Conditions(1) Min. Typ.(2) Max. Unit
VIH Input HIGH Level Guaranteed Logic HIGH Level 2 — — V
VIL Input LOW Level Guaranteed Logic LOW Level — — 0.8 V
IIH Input HIGH Current (Input pins)(5) VCC = Max. VI = VCC ——±1µA
Input HIGH Current (I/O pins)(5) ——±1
IIL Input LOW Current (Input pins)(5) VI = GND — — ±1
Input LOW Current (I/O pins)(5) ——±1
IOZH High Impedance Output Current VCC = Max. VO = 2.7V — — ± 1 µA
IOZL (3-State Output pins)(5) VO = 0.5V — — ± 1
VIK Clamp Diode Voltage VCC = Min., IIN = –18mA — –0.7 –1.2 V
IOS Short Circuit Current VCC = Max., VO = GND(3) –80 –140 –250 mA
VHInput Hysteresis — — 100 — m V
ICCL Quiescent Power Supply Current VCC = Max — 5 500 µA
ICCH VIN = GND or VCC
ICCZ
DC ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Following Conditions Apply Unless Otherwise Specified:
Industrial: TA = –40°C to +85°C, VCC = 5.0V ±10%
NOTES:
1. For conditions shown as Min. or Max., use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 5.0V, +25°C ambient.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Duration of the condition can not exceed one second.
5. This test limit for this parameter is ±5µA at TA = –55°C.
OUTPUT DRIVE CHARACTERISTICS