PNPN Switch ET0131, ET0141, ET0151, ET0201 Example of application circuit (ignition) External Dimensions (Unit: mm) 0.6 0.05 T2 marking Discharge gap T1 5.0 0.2 62.3 0.7 T2 2.7 0.2 Weight: Approx. 2.6g Absolute Maximum Ratings Ratings Parameter Symbol Non-repetitive surge voltage Repetitive off-state voltage VDSM+ VDRM+ RMS on-state current IT(RMS) 0.6 Surge on-state current ITSM Rate-of-rise of on-state current diT/dt ET0131 ET0141 ET0151 ET0201 Conditions V C=2000pF, Rs=5,Tj=25C, Vc=600V(T2+,T1-), 1 shot, Refer to Fig1 Tj= - 40C +125C, only(T2+, T1- ) A DC, T 80 A Ta=25C, Wp=10S, Half-sine-wave 1cycle, peak value, f=50Hz 30 A/sec. 600 90 Unit 115 V 115 170 Junction temperature Tj - 40 +125 C Storage temperature Tstg - 40 +125 C 112C Electrical Characteristics Ratings Parameter Symbol VBO+ IBO+ Breakeover voltage Breakeover current Off-state leakage current Holding Current On-state voltage Insulation resistance Thermal resistance ET0131 ET0141 ET0151 ET0201 120 138 134 150max 146 142 157 190 210 100max Unit V A A IDRM+ IH+ 10max IH - 20typ VT 2.5 R 100min M Rth(j- ) 20max C/W 25 typ Conditions VD =VDRM+ mA V IT = 10A Between lead and side of plastic body (Except surface for leads) Between junction and lead : Under development Fig.1 Hg Relay SW1 SW2 Rs=5 Vd=600V C=2000pF (Vc =600V) 68 + - As the SW2 remains open, close the SW1 to charge the capacitor, C= 2000pF, up to 600V to open the SW1. After the capacitor charged up to the certain voltage, close the SW2 and impose voltage on the die. ET0131, ET0141, ET0151, ET0201 69