Series PVD13NPbF Microelectronic Power IC HEXFET(R) Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-100V DC, 550mA General Description The PVD13 Series DC Relay (PVD) is a single-pole, normally open, solid-state replacement for electromechanical relays used for general purpose switching of analog signals. It utilizes International Rectifier's HEXFET power MOSFET as the output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the photovoltaic generator. The PVD13 Series overcomes the limitations of both conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. These advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. The PVD13 can switch analog signals from thermocouple level to 100 Volts peak DC. Signal frequencies into the RF range are easily controlled and switching rates up to 450Hz are achievable. The extremely small thermally generated offset voltages allow increased measurement accuracies. These relays are packaged in 8-pin, molded DIP packages and available with either thru-hole or surface-mount ("gull-wing") leads, in plastic shipping tubes. Bounce-Free Operation 1010 Off-State Resistance 1,000 V/sec dv/dt 5 mA Input Sensitivity 4,000 VRMS I/O Isolation Solid-State Reliability UL Recognized ESD Tolerance: 4000V Human Body Model 500V Machine Model Part Identification Applications Features Process Control Data Acquisition Test Equipment Multiplexing and Scanning PVD1352NPbF PVD1354NPbF thru-hole PVD1352NSPbF PVD1354NSPbF surface-mount (gull-wing) (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 29, 2015 Series PVD13NPbF Electrical Specifications (-40C TA +85C unless otherwise specified) INPUT CHARACTERISTICS PVD1352N Minimum Control Current (see figures 1 and 2) For 500mA Continuous Load Current For 550mA Continuous Load Current For 350mA Continuous Load Current PVD1354N DC mA@25C mA@40C mA@85C 2 5 5 Maximum Control Current for Off-State Resistance at 25C Control Current Range (Caution: current limit input LED. See figure 6) 10 A(DC) 2.0 to 25 mA(DC) 6.0 V(DC) Maximum Reverse Voltage OUTPUT CHARACTERISTICS PVD1352N Operating Voltage Range Units PVD1354N Units 0 to + 100 V(PEAK) 550 mA(DC) Max. T(on) @ 12mA Control, 50 mA Load, 100 VDC 150 s Max. T(off) @ 12mA Control, 50 mA Load, 100 VDC 125 s Maxiumum Load Current 40C I LED 5mA Response Time @25C (see figures 7 and 8) Max. On-state Resistance 25C (Pulsed) (fig. 4) 200 mA Load, 5mA Control Min. Off-state Resistance 25C @ 80 VDC (see figure 5) 10 10 8 Max. Thermal Offset Voltage @ 5.0mA Control 10 0.2 Min. Off-State dv/dt GENERAL CHARACTERISTICS V/s 20 pF @ 50VDC (PVD1352N and PVD1354N) Units 4000 VRMS Dielectric Strength: Input-Output Insulation Resistance: Input-Output @ 90VDC 10 @ 25C - 50% RH 1.0 pF 12 Maximum Capacitance: Input-Output Max. Pin Soldering Temperature (1.6mm below seating plane, 10 seconds max.) volts 1000 Typical Output Capacitance Ambient Temperature Range: 1.5 +260 Operating -40 to +85 Storage -40 to +100 C International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 29, 2015 Series PVD13NPbF 700 600 500 Load Current (mA) Max. Load Current (mA) 800 ILED>5mA 400 300 200 ILED=2mA 100 0 0 20 40 60 80 100 ILED (mA) Ambient Temperature (C) Figure 1. Current Derating Curves Figure 2. Typical Control Current Requirements 1000 900 800 700 600 500 400 300 200 Load Current (mA) 25C 40C 60C 85C I LED = 5mA, Forced Air 100 0 0.0 0.5 1.0 1.5 5 mA Control lD = 100 mA 2.0 VDD (Volts) Figure 3.Typical On Characteristics 3 Rd(on) (Normalized to 25C) Pulsed, 25C www.irf.com (c) 2015 International Rectifier Ambient Temperature (C) Figure 4. Typical Normalized On-Resistance Submit Datasheet Feedback April 29, 2015 IDOff/IDOff 25C Input Current (mA) Series PVD13NPbF LED Forward Voltage Drop (Volts DC) Ambient Temperature (C) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) y ( ) Delay Time (S) 1000 Ton Tdly 100 Toff 10 0 5 10 15 20 I LED (mA) Figure 7.Typical Delay Times 4 www.irf.com (c) 2015 International Rectifier Figure 8. Delay Time Definitions Submit Datasheet Feedback April 29, 2015 200 Typical Capacitance (pF) 180 Typical Capacitance pF) Normalized Transfer Ratio Normalized Control Threshold Current Series PVD13NPbF 160 140 120 100 80 60 40 20 0 0 10 20 30 40 Ambient Temperature C VDS Drain to Source Voltage Figure 9. Typical Control Threshold and Transfer Ratio Figure 10. Typical Output Capacitance 50 Wiring Diagram 5 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 29, 2015 Series PVD13NPbF Case Outlines 01-2013 00 (MS-001AB) 01-2019 00 Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ 6 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 29, 2015 Series PVD13NPbF Qualification information Industrial (per JEDEC JESD47I guidelines) Qualification level Moisture Sensitivity Level PVD1352NPbF PVD1354NPbF PVD1352NSPbF PVD1354NSPbF RoHS compliant N/A MSL4 (per JEDEC J-STD-020E & JEDEC J-STD-033C ) Yes Qualification standards can be found at International Rectifier's web site: http://www.irf.com/product-info/reliability Applicable version of JEDEC standard at the time of product release Revision History Date 4/29/2015 Comments * Added Qualification Information Table on page 7 * Updated data sheet with new IR corporate template IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA Data and specifications subject to change without notice To contact International Rectifier, please visit http://www.irf.com/whoto-call/ 7 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 29, 2015