58mm (2.3 INCH) 8x8 DOT MATRIX DISPLAY P/N: TA23-11GWA GREEN Features Description *2.3 INCH MATRIX HEIGHT. The Green source color devices are made with Gallium *DOT SIZE 5mm. Phosphide Green Light Emitting Diode. *LOW CURRENT OPERATION. *HIGH CONTRAST AND LIGHT OUTPUT. *COMPATIBLE WITH ASCII AND EBCDIC CODES. *STACKABLE HORIZONTALLY. *COLUMN CATHODE AND COLUMN ANODE AVAILABLE. *EASY MOUNTING ON P.C. BOARDS OR SOCKETS. *MULTICOLOR AVAILABLE. *MECHANICALLY RUGGED. *STANDARD : GRAY FACE, WHITE DOT. *RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2460 REV NO: V.6 DATE: NOV/29/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000172 Selection Guide Part No. Dice TA23-11GWA Iv (ucd) @ 10mA Lens Type GREEN (GaP) WHITE DIFFUSED Description Min. Typ. 1900 10500 Column Anode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Green D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 565 nm IF=20mA Green 568 nm IF=20mA Spectral Line Half-width Green 30 nm IF=20mA C Capacitance Green 15 pF VF=0V;f=1MHz VF Forward Voltage Green 2.2 2.5 V IF=20mA IR Reverse Current Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2460 REV NO: V.6 DATE: NOV/29/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000172 Green TA23-11GWA SPEC NO: DSAD2460 REV NO: V.6 DATE: NOV/29/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000172 PACKING & LABEL SPECIFICATIONS TA23-11GWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2460 REV NO: V.6 DATE: NOV/29/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000172