ALUMINUM ELECTROLYTIC CAPACITORS
PJseries
Low Impedance, For Switching Power Supplies
Low impedance and high reliability withstanding 5000 hours load life
at +105˚C (3000 / 2000 hours for smaller case sizes as specified below).
Capacitance ranges available based on the numerical values in E12 series under JIS.
Ideally suited for use of switching power supplies.
Compliant to the RoHS directive (2002/95/EC).
Specifications
Category Temperature Range
Rated Voltage Range
Rated Capacitance Range
Capacitance Tolerance
Leakage Current
Tangent of loss angle (tan
δ
)
Stability at Low Temperature
Endurance
Marking
Performance CharacteristicsItem –55 to +105˚C (6.3 to 100V), –40 to +105˚C (160 to 400V), –25 to +105˚C (450V)
6.3 to 450V
0.47 to 15000µF
±20% at 120Hz, 20˚C
Rated Voltage (V)
Leakage current
120Hz
After 1 minute's application of rated voltage, leakage current is not more
than 0.03CV or 4 (µA), whichever is greater.
Printed with white color letter on dark brown sleeve.
The specifications listed at right shall be met when the
capacitors are restored to 20˚Cafter D.C. bias plus rated ripple
current is applied for 5000 hours (2000 hours for φD=5 and 6.3,
3000 hours for φD=8) at 105˚C, the peak voltage shall not
exceed the rated voltage.
Shelf Life After storing the capacitors under no load at 105˚C for 1000
hours and then performing voltage treatment based on JIS C
5101-4 clause 4.1 at 20°C, they shall meet the specified
values for the endurance characteristics listed above.
160 to 450
CV <
=1000 :
I
= 0.1CV+40 (µA) max. (1 minute's)
CV
>
1000 :
I
= 0.04CV+100 (µA) max. (1 minute's)
Rated voltage (V)
Impedance
ratio (
MAX.
)
Z–25˚C / Z+20˚C
Z–40˚C / Z+20˚C
Z–55˚C / Z+20˚C
6.3
•
10
—
—
4
16
—
—
3
25
•
35
—
—
3
50 to 100
—
—
2
160
•
200
—
4
—
250
—
6
—
315
•
350
—
8
—
400
—
10
—
450
15
—
—
Radial Lead Type
PJ
6.3 to 100
Type numbering system (Example : 25V 470µF)
Dimension table in next pages.
Leakage current
tan δ
Capacitance change
Less than or equal to the initial specified value
200% or less than the initial specified value
Within ±20% of the initial capacitance value
Leakage current
tan δ
Capacitance change
Less than or equal to the initial specified value
150% or less than the initial specified value
Within ±20% of the initial capacitance value
Please refer to page 20, 21, 22 about the formed or taped product spec.
Please refer to page 4 for the minimum order quantity.
• Please refer to page 20 about the end seal configulation.