DSD / DLD Series * Time-delay solid-state relays * Ratings from 10A to 50A @ 240 VAC * External time adjustment * DC control * Zero-crossing (resistive loads) output * Ideal for compressor applications * CE Compliant to EN60950-1 PRODUCT SELECTION Description 3.5-15 VDC Control 3.5-15 VDC Control 10 A 25 A 50 A DSD2410 DLD2410 DSD2425 DLD2425 DSD2450 DLD2450 10 A 25 A 50 A 10 0.04 120 1.6 1.48 60 0.5 25 0.04 250 1.6 1.02 260 0.5 50 0.04 625 1.6 0.63 1620 0.5 OUTPUT SPECIFICATIONS (voltage) (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/sec] (2) 48-280 600 10 500 OUTPUT SPECIFICATIONS (current) (1) Description Maximum Load Current (3) [Arms] Minimum Load Current (3) [Arms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [C/W] Maximum It for Fusing (8.3 msec) [Asec] Minimum Power Factor (with Maximum Load) INPUT SPECIFICATIONS (1) Description Control Voltage Range Maximum Turn-On Voltage Maximum Turn-Off Voltage Typical Input Current Nominal Input Impedance Maximum Turn-On Time [msec] (4) Maximum Turn-Off Time [msec] Maximum Reset Time [sec] (5) DC Control 3.5-15 VDC 3.5 VDC 1.0 VDC 3.4 mA @ 5 Vdc, 11.4 mA @ 15 Vdc 1500 Ohm Adlustable, See Table 1/2 Cycle 100 TYPICAL TURN-ON DELAY Resistor 0 (Short) 10K 100K 470K 1.0M (4) Time DSD Time DLD .10 sec .19 sec .94 sec 4.0 sec 8.3 sec 1.6 sec 3.1 sec 15 sec 64 sec 133 sec GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Parameters 4000 Vrms 1010 Ohm -30 to 80C -40 to 125C 3.0 oz. (43g) Themally Conductive Epoxy Screws and saddle Clamps Furnished, Unmounted GENERAL NOTES 1) 2) 3) 4) 5) All parameters at 25C unless otherwise specified. Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 Heat sinking required, see derating curves. Timing Resistor may be as high as 10M Ohm with performance dependent on resistor quality Before and after time-out. WIRING DIAGRAM THERMAL DERATE INFORMATION AGENCY APPROVALS EN60950 : Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: UL E116949 Rev. 122010 ANNEX - ENVIROMENTAL INFORMATION