ADVANCED LINEAR DEVICES, INC. e TM EPAD EN (R) AB LE D ALD114804/ALD114804A/ALD114904/ALD114904A QUAD/DUAL N-CHANNEL DEPLETION MODE EPAD(R) MATCHED PAIR MOSFET ARRAY VGS(th)= -0.4V GENERAL DESCRIPTION APPLICATIONS ALD114804/ALD114804A/ALD114904/ALD114904A are monolithic quad/dual NChannel MOSFETS matched at the factory using ALD's proven EPAD(R) CMOS technology. These devices are intended for low voltage, small signal applications. They are excellent functional replacements for normally-closed relay applications, as they are normally on (conducting) without any power applied, but could be turned off or modulated when system power supply is turned on. These MOSFETS have the unique characteristics of, when the gate is grounded, operating in the resistance mode for low drain voltage levels and in the current source mode for higher voltage levels and providing a constant drain current. * Functional replacement of Form B (NC) relays * Ultra low power (nanowatt) analog and digital circuits * Ultra low operating voltage (<0.2V) analog and digital circuits * Sub-threshold biased and operated circuits * Zero power fail safe circuits in alarm systems * Backup battery circuits * Power failure and fail safe detector * Source followers and high impedance buffers * Precision current mirrors and current sources * Capacitives probes and sensor interfaces * Charge detectors and charge integrators * Differential amplifier input stage * High side switches * Peak detectors and level shifters * Sample and Hold * Current multipliers * Discrete analog switches and multiplexers * Discrete voltage comparators ALD114804/ALD114804A/ALD114904/ALD114904A MOSFETS are designed for exceptional device electrical characteristics matching. As these devices are on the same monolithic chip, they also exhibit excellent temperature tracking characteristics. They are versatile as design components for a broad range of analog applications, such as basic building blocks for current sources, differential amplifier input stages, transmission gates, and multiplexer applications. Besides matched pair electrical characteristics, each individual MOSFET also exhibits well controlled parameters, enabling the user to depend on tight design limits corresponding to well matched characteristics. These depletion mode devices are built for minimum offset voltage and differential thermal response, and they are suitable for switching and amplifying applications in single supply (0.4V to + 5V ) or dual supply (+/- 0.4V to +/-5V) systems where low input bias current, low input capacitance and fast switching speed are desired. These devices exhibit well controlled turn-off and sub-threshold charactersitics and therefore can be used in designs that depend on sub-threshold characteristics. The ALD114804/ALD114804A/ALD114904/ALD114904A are suitable for use in precision applications which require very high current gain, beta, such as current mirrors and current sources. A sample calculation of the DC current gain at a drain current of 3mA and gate input leakage current of 30pA = 100,000,000. It is recommended that the user, for most applications, connect V+ pin to the most positive voltage potential (or left open unused) and V- and N/C pins to the most negative voltage potential in the system. All other pins must have voltages within these voltage limits. FEATURES * Depletion mode (normally ON) * Precision Gate Threshold Voltages: -0.4V +/- 0.02V * Nominal RDS(ON) @VGS=0.0V of 5.4K * Matched MOSFET to MOSFET characteristics * Tight lot to lot parametric control * Low input capacitance * VGS(th) match (VOS) -- 20mV * High input impedance -- 1012 typical * Positive, zero, and negative VGS(th) temperature coefficient * DC current gain >108 * Low input and output leakage currents ORDERING INFORMATION Operating Temperature Range* 0C to +70C 0C to +70C 16-Pin 16-Pin 8-Pin 8-Pin Plastic Dip SOIC Plastic Dip SOIC Package Package Package Package ALD114804APC ALD114804ASC ALD114904APA ALD114904ASA ALD114804 PC ALD114804SC ALD114904PA ALD114904SA PIN CONFIGURATION ALD114804 N/C* 1 GN1 2 DN1 3 S12 4 V- 5 DN4 6 GN4 7 N/C* 8 V- V- M1 M2 V+ VM4 M3 16 N/C* 15 GN2 14 DN2 13 V+ 12 S34 11 DN3 10 GN3 9 V- V- N/C* PC, SC PACKAGES ALD114904 N/C* 1 GN1 2 DN1 3 S12 4 V- V- M1 M2 V- 8 N/C* 7 GN2 6 DN2 5 V- PA, SA PACKAGES *N/C pins are internally connected. Connect to V- to reduce noise * Contact factory for industrial temp. range or user-specified threshold voltage values Rev 1.0-0506 (c)2005 Advanced Linear Devices, Inc. 415 Tasman Drive, Sunnyvale, California 94089-1706 Tel: (408) 747-1155 Fax: (408) 747-1286 www.aldinc.com ABSOLUTE MAXIMUM RATINGS Drain-Source voltage, VDS Gate-Source voltage, VGS Power dissipation Operating temperature range PA, SA, PC, SC package Storage temperature range Lead temperature, 10 seconds 10.6V 10.6V 500 mW 0C to +70C -65C to +150C +260C OPERATING ELECTRICAL CHARACTERISTICS V+ = +5V (or open) V- = -5V TA = 25C unless otherwise specified CAUTION: ESD Sensitive Device. Use static control procedures in ESD controlled environment. ALD114808A / ALD114908A Parameter Symbol Min Typ Gate Threshold Voltage VGS(th) -0.42 Offset Voltage VGS1-VGS2 ALD110848 / ALD114908 Max Min Typ Max Unit -0.40 -0.38 -0.44 -0.40 -0.36 V IDS =1A VDS = 0.1V VOS 2 5 7 20 mV IDS =1A VGS1-VGS2 Tempco VOS 5 5 V/ C VDS1 = VDS2 GateThreshold Tempco VGS(th) -1.7 0.0 +1.6 -1.7 0.0 +1.6 mV/ C ID = 1A ID = 20A, VDS = 0.1V ID = 40A On Drain Current IDS (ON) 12.0 3.0 12.0 3.0 mA VGS = +9.1V VGS = +3.6V VDS = +5V Forward Transconductance GFS 1.4 1.4 mmho VGS =+3.6 V VDS = +8.6V Transconductance Mismatch GFS 1.8 1.8 % Output Conductance GOS 68 68 mho VGS =+3.6V VDS = +8.6V Drain Source On Resistance RDS (ON) 500 500 VDS = 0.1V VGS = +3.6V Drain Source On Resistance RDS (ON) 5.4 5.4 K VDS = 0.1V VGS = +0.0V Drain Source On Resistance Tolerance RDS (ON) 10 10 % Drain Source On Resistance Mismatch RDS (ON) 0.5 0.5 % Drain Source Breakdown Voltage BVDSX Drain Source Leakage Current1 IDS (OFF) Gate Leakage Current1 10 10 Test Condition V IDS = 1.0A VGS = -1.4V 10 100 4 10 100 4 pA nA VGS = -1.4V, VDS =+5V TA = 125C IGSS 3 30 1 3 30 1 pA nA VDS = 0V VGS = +10V TA =125C Input Capacitance CISS 2.5 2.5 pF Transfer Reverse Capacitance CRSS 0.1 0.1 pF Turn-on Delay Time ton 10 10 ns V+ = 5V RL= 5K Turn-off Delay Time toff 10 10 ns V+ = 5V RL= 5K 60 60 dB f = 100KHz Crosstalk Notes: 1 Consists of junction leakage currents ALD114804/ALD114804A/ALD114904/ALD114904A Advanced Linear Devices 2